backcut on valves, cleaned up runners, gasket matched and pinned studs. The engine has 9:1 compression 4 bolt stock bottom, (heads) 2.02/1.60 valves with 3 angle blended bowls unshrouded valves and a 30 deg. The engine I am replacing it with was built by a local machine shop, I was told it would have a conservative 350+ 5000RPM) I was just wondering on your take on it. Start the engine and bring to break-in rpm.I am in the process of replacing the 350/260 engine in my scorpion 230. Slow idle speeds may result in severe cam and lifter wear. Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up. Oil/additive must contain Zinc designed for use with flat tappet camshafts.

Recommended Valve Springs for OEM heads: Edelbrock part #5802 non-rotator/# 5902 Rotator In order for this Performer-Plus cam and lifter kit to be covered under ANY WARRANTY you must use either the correct Edelbrock Sure Seat valve springs or the stock original equipment valve springs.

For more information, visit Installation Notes

WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. 442' - Lobe separation: 112 Degree - Intake Center Line: 107 Degree - Vacuum: 14' Camshaft specifications: - Intake duration: 204 Degrees - Exhaust duration: 214 Degrees - Intake lift. This cam produced 320HP and 382 Ft Lbs of Torque when paired with Performer EPS intake manifold #2701 and Performer cylinder heads #60909. All camshafts include flat tappet lifters (except for cams designed for use with stock roller lifters), assembly lube and instructions. In the manifold section you'll find torque graphs showing the power gains from Performer manifolds and Performer-Plus cams. You can expect a major improvement in throttle response and torque. The Performer-Plus #2102 is a smooth idling cam for daily drivers, trucks, vans, RVs and 4x4s. Performer-Plus camshafts should be matched with Performer manifolds for vehicles operating from off-idle to 5500 rpm. Edelbrock Performer-Plus Camshaft #2102 is designed for 265-400 Chevy V8 engines from 1957-86 and produce optimum torque from the low-end to the mid-range.

Chevy 350 rv cam specs